Prototype JMP Clamp

Post your ideas for creating specialty jigs and fixtures.

Moderator: Michael

Prototype JMP Clamp

Postby rwest » Mon Feb 07, 2011 6:27 pm


Over the holidays John Economaki sent me this clamp to try out and give my opion of. Well he didn't tell me it was a clamp, he just said he was sending an accessory for the Jointmaker to me to try out!

Here is a picture of the clamp in all its anodized glory:

I used the long leg to get a good hold on larger pieces:

I used the shorter leg on smaller stock:

The clamp works great and holds stock down very tight but since I had only one, I used a trap clap on the far end to prevent any swivel.

Posts: 265
Joined: Mon Apr 28, 2008 4:59 pm

Return to Jointmaker Pro Jig/Fixtures Accessories Idea Bank

Who is online

Users browsing this forum: No registered users and 2 guests