pitch screw barrel nut / pitch adjuster

Questions and comments concerning the assembly of the Jointmaker Pro

Moderator: Michael

pitch screw barrel nut / pitch adjuster

Postby Charles » Sat Dec 04, 2010 10:52 pm

Thought this would be helpful.

I found a small burr on the side of the pitch screw barrel nut. Unfortunately only after spending 10-15 minutes trying to attach the pitch adjuster. The burr was causing the barrel nut to skew keeping me from lining up the threads.

A small needle file corrected.
Charles
 
Posts: 7
Joined: Sun Apr 11, 2010 12:36 pm

Postby John » Mon Dec 06, 2010 4:59 pm

Charles;

I had the same issue on one of the JMP v2's I assembled last week. Thanks for sharing, this burr is duly noted for inspection on the next run.

John
John
Site Admin
 
Posts: 187
Joined: Thu Apr 10, 2008 11:54 am


Return to Jointmaker Pro Set-Up & Assembly FAQ

Who is online

Users browsing this forum: No registered users and 1 guest

cron