Can the JMP Rip boards?

Discuss general thoughts on the Jointmaker Pro.

Moderator: Michael

Can the JMP Rip boards?

Postby davestys@gmail.com » Tue Apr 15, 2014 9:33 am

Can this tool rip boards? Or is that not the intended purpose?
davestys@gmail.com
 
Posts: 1
Joined: Tue Apr 15, 2014 5:56 am

Re: Can the JMP Rip boards?

Postby rwest » Thu Apr 17, 2014 2:44 pm

Hello Dave,

Yes, it will rip up to about 6" in length. The blade teeth tend to load up a little more, so cleaning the teeth with a small brush every couple strokes makes it easier. There is a rip blade available as well, keep in mind that dovetails are mostly rip cuts, but very short and the standard crosscut blade works just fine for them.

Rutager
rwest
 
Posts: 264
Joined: Mon Apr 28, 2008 4:59 pm


Return to Jointmaker Pro General Questions

Who is online

Users browsing this forum: No registered users and 1 guest

cron