Gears Stuck

Moderator: Michael

Gears Stuck

Postby dr.nono@netzero.com » Sat Aug 22, 2015 9:42 pm

I was sawing some very soft pine with the keel at a 45 degree angle and advancing the crank a quarter of a turn each pass. After about 60 or so cuts 5/8 inch deep the blade got stuck in the raised position. The crank turns the front shaft but the attached gear doesn't move, the shaft just spins freely on the gear. What is the best way to lower the blade back down and tighten up the connection between the front gear and the front shaft?
dr.nono@netzero.com
 
Posts: 2
Joined: Sat Aug 22, 2015 9:34 pm

Return to Precision Fence Questions

Who is online

Users browsing this forum: No registered users and 1 guest

cron