Instructions would be nice....

Moderator: Michael

Instructions would be nice....

Postby » Fri Dec 02, 2011 11:24 am

I've been using CAD for years as a crutch to figure angles; that's what computers are for. As such, I've forgotten how to do a lot of thing the mathematical way.

The video is nice, but it doesn’t explain much how to use the AMP v2 and the app to perform functions in its 3 minutes and 41 seconds.

How would I set miter angles for dissimilar stock width for other than 90 degrees? Is the Circumference Calculator just there to be handy, or is there some AMP v2 specific use for it? I’ve more questions, but I think you get the gist.

Just a little cheat sheet would be nice for those of us who are hobbled by many years distant from practicing geometry in the shop.
Posts: 3
Joined: Thu Mar 31, 2011 6:21 pm

Re: Instructions would be nice....

Postby » Tue Dec 13, 2011 11:24 am

We will do videos on the AMP app functions in the first quarter of 2012.

Good suggestion.

Posts: 11
Joined: Mon Mar 28, 2011 4:57 pm

Re: Instructions would be nice....

Postby » Fri Jun 29, 2018 9:03 pm

I'm sorry, but I just can't follow the instructions for downloading the app for the AMP v2. I thought there was going to be a video made to cover this. Maybe you just can't teach an old dog new tricks
Posts: 1
Joined: Sun Feb 15, 2015 3:47 am

Re: Instructions would be nice....

Postby rwest » Sun Jul 01, 2018 4:14 pm

You should just be able to go to the App Store and download powerOne pro then open it up on your device click on the upper left corner that says “templates” then search for Angle Master Pro.
Posts: 265
Joined: Mon Apr 28, 2008 4:59 pm

Return to The AMP-v2 App

Who is online

Users browsing this forum: No registered users and 1 guest