Separate .5 inch nicker hone?

A discussion about the use of the plane. Also a great place to exchange ideas, tricks, and set-ups.

Moderator: Michael

Separate .5 inch nicker hone?

Postby » Mon Apr 16, 2012 8:28 am

Do you need a separate .5" nicker hone for the dado profile? (I would rather not have to buy separate hones.) I have the .25" dado nicker hone, but it is ground at a different angle. Seems like one hone should work for all the different dado nickers.

Looking forward to putting the HP6-V2 to work.

Thanks in advance!
Posts: 9
Joined: Fri Mar 25, 2011 1:19 pm

Return to HP-6v2

Who is online

Users browsing this forum: No registered users and 1 guest