Cutting Non-Ferrous Metal; Re-cycle a Trashed Blade!

Moderator: Michael

Cutting Non-Ferrous Metal; Re-cycle a Trashed Blade!

Postby rwest » Tue Feb 12, 2013 6:05 pm


Due to my inattention, I forgot that I didn't need to tilt the blade because I was using the Bias-arm, so I ended up cutting slightly- very slightly into my precision fence before I realized where the weird sound was coming from. It cut the aluminum and also trashed my blade. Since the blade was now worthless for normal use, I figured I would see if it could cut some 1/8" brass bar stock, and it did, so I tried a few other pieces of brass, copper and aluminum, all with the same blade. It got pretty toothless after a while, but it still cut. To set up for cut, use a very minimal pitch, raise the blade height just a few degrees each pass and if the blade starts getting toothless, just take passes along the section of blade between the gaps.
JMP Metal 003.JPG
3/8" brass tubing.
JMP Metal 003.JPG (38.08 KiB) Viewed 10707 times
JMP Metal 007.JPG
Assorted pieces I cut.
JMP Metal 007.JPG (39.46 KiB) Viewed 10707 times
JMP Metal 005.JPG
Blade getting ugly, cut still pretty.
JMP Metal 005.JPG (35.53 KiB) Viewed 10707 times
JMP Metal 004.JPG
Tubing in the cut.
JMP Metal 004.JPG (30.71 KiB) Viewed 10707 times
Posts: 265
Joined: Mon Apr 28, 2008 4:59 pm

Re: Cutting Non-Ferrous Metal; Re-cycle a Trashed Blade!

Postby » Wed Oct 10, 2018 3:01 am

I am not a mechanical student so that question is far away from my thinking but I can share a source of knowledge where you can gain some point here so go through and get the answer of your question easily, thank you me later anyway.
Posts: 1
Joined: Wed Oct 10, 2018 2:57 am

Return to Jointmaker Pro Joinery Tips and Cutting Techniques

Who is online

Users browsing this forum: No registered users and 2 guests