Strict Standards: Non-static method phpbb_feed_factory::init() should not be called statically in /home/bridgec/src.bridgecitytools.com/magento/discussion/feed.php on line 66
[phpBB Debug] PHP Notice: in file /feed.php on line 171: Cannot modify header information - headers already sent by (output started at /feed.php:66)
[phpBB Debug] PHP Notice: in file /feed.php on line 172: Cannot modify header information - headers already sent by (output started at /feed.php:66)
BridgeCityTools.com Serving Woodworkers Worldwide for a Quarter Century! 2012-07-24T13:06:50-07:00 https://www.bridgecitytools.com/discussion/feed.php?f=29&t=353 2012-07-24T13:06:50-07:00 https://www.bridgecitytools.com/discussion/viewtopic.php?t=353&p=1274#p1274 <![CDATA[Re: Bearings]]>
Gary

Statistics: Posted by garyfergus@hotmail.com — Tue Jul 24, 2012 1:06 pm


]]>
2012-07-24T10:23:10-07:00 https://www.bridgecitytools.com/discussion/viewtopic.php?t=353&p=1273#p1273 <![CDATA[Re: Bearings]]> Once you get the correct tension (as soon as the slop is removed), use a 5/64" hex wrench in the back to tighten that set screw into the front while holding the front screw still. This will jam the two screws together. The front screw should not rotate when you open and close the AMPv2.

Hope this helps!
Michael

Statistics: Posted by Michael — Tue Jul 24, 2012 10:23 am


]]>
2012-07-24T07:32:38-07:00 https://www.bridgecitytools.com/discussion/viewtopic.php?t=353&p=1272#p1272 <![CDATA[Bearings]]>
It's no problem to tighten them up, but I was wondering if you have any advice on the appropriate torque?

Thanks,

Gary

Statistics: Posted by garyfergus@hotmail.com — Tue Jul 24, 2012 7:32 am


]]>