Strict Standards: Non-static method phpbb_feed_factory::init() should not be called statically in /home/bridgec/src.bridgecitytools.com/magento/discussion/feed.php on line 66
[phpBB Debug] PHP Notice: in file /feed.php on line 171: Cannot modify header information - headers already sent by (output started at /feed.php:66)
[phpBB Debug] PHP Notice: in file /feed.php on line 172: Cannot modify header information - headers already sent by (output started at /feed.php:66)
BridgeCityTools.com Serving Woodworkers Worldwide for a Quarter Century! 2014-04-19T10:44:50-07:00 https://www.bridgecitytools.com/discussion/feed.php?f=23&t=248 2014-04-19T10:44:50-07:00 https://www.bridgecitytools.com/discussion/viewtopic.php?t=248&p=1490#p1490 <![CDATA[Re: Cuts Not Straight in Wider Stock]]>
It looks like the email thread that you posted was cut off before solutions were discussed. If you still have it and could re-post it that would be great.
Thanks,
Dave

Statistics: Posted by dave@wiseriverforestry.com — Sat Apr 19, 2014 10:44 am


]]>
2011-02-14T17:13:15-07:00 https://www.bridgecitytools.com/discussion/viewtopic.php?t=248&p=973#p973 <![CDATA[Cuts Not Straight in Wider Stock]]>
"I purchased, assembled, and have been using the JM-SW for about 2 weeks. Yesterday in attempting to make a 45 degree miter cut in 1/2" thick x 3 " wide stock I ended up with the cut not coming out square. The fence is square to the blade, the blade tracks properly and I get square crosscuts...I even get square miter cuts in material that is not as wide (like 1" wide). Please tell me what I might need to do to correct this."
-John West

[b]John:

I am assuming you are using the standard blade which has 28 teeth per inch. With a 3â€

Statistics: Posted by John — Mon Feb 14, 2011 5:13 pm


]]>