Comments on: Sneak Peek at Two New HP6v2 Kits…. http://www.bridgecitytools.com/blog/2009/04/07/sneak-peek-at-two-new-hp6v2-kits/ Behind the Scenes at Bridge City Tool Works Sat, 04 Feb 2012 00:27:58 +0000 hourly 1 http://wordpress.org/?v=3.3.1 By: John http://www.bridgecitytools.com/blog/2009/04/07/sneak-peek-at-two-new-hp6v2-kits/comment-page-1/#comment-92 John Wed, 08 Apr 2009 16:33:17 +0000 http://www.bridgecitytools.com/blog/?p=510#comment-92 We have a corner cove in four sizes, but no plans at the moment for a surface cove. HOWEVER, if you have one of the corner cove kits, you can run the iron deep for surface coves--I just tried it and it works well. You need "plane friendly" grain and light passes. --John We have a corner cove in four sizes, but no plans at the moment for a surface cove. HOWEVER, if you have one of the corner cove kits, you can run the iron deep for surface coves–I just tried it and it works well. You need “plane friendly” grain and light passes.

–John

]]> By: kwcabs http://www.bridgecitytools.com/blog/2009/04/07/sneak-peek-at-two-new-hp6v2-kits/comment-page-1/#comment-89 kwcabs Wed, 08 Apr 2009 06:25:36 +0000 http://www.bridgecitytools.com/blog/?p=510#comment-89 This is a nice addition, is there any chance you're going to even make a profile just like this without the rabbet sections? In other words just a cove by itself? This is a nice addition, is there any chance you’re going to even make a profile just like this without the rabbet sections? In other words just a cove by itself?

]]>